How to Reset the BladeCenter Management ModuleИсточник: www.ibm.com AbstractThe IBM BladeCenter management module has a reset button with which you can reset the module and return it to the factory defaults. For related information about this topic, refer to the following IBM Redbooks publication: ContentsThe management module reset button is shown in the following figure. Use a straightened paper clip or similar item to access it. The reset button has two uses:
After the network configuration has been reset, you can access the Web interface to reconfigure it. To do this, you will need to know the management module's IP address. This can be done as follows:
Note: Because it is possible to reset the passwords using the reset button, you should ensure that your BladeCenter chassis is physically secure so that only authorized personnel can physically access the reset button.
Special NoticesThis material has not been submitted to any formal IBM test and is published AS IS. It has not been the subject of rigorous review. IBM assumes no responsibility for its accuracy or completeness. The use of this information or the implementation of any of these techniques is a client responsibility and depends upon the client's ability to evaluate and integrate them into the client's operational environment. publib-b.boulder.ibm.com
|
Обновлено 16.10.2014 14:15 |